# Call at +8619957767763

# Leave a message dennis@bestwin-tools.com

Pneumatic Tools Manufacturers
Blog
Home

Blog

Notes on the use of bimetallic

Notes on the use of bimetallic

  • Jul 15,2020

Notes on the use of bimetallic hole Saw:
1. make sure the opener is jammed and clamped and then idling to confirm the swing.
2. to confirm the direction of rotation, must be clockwise rotation (positive), to confirm that the revolutions per minute and the opening of the diameter of the cutting material is appropriate.
3., the opening should be perpendicular to the cutting material surface, especially when using a flashlight, should be kept stable, can not tilt or shake back and forth, otherwise it will damage the opener.
4. in the center drill (drill positioning) is drilled, gently force that the opening edge is not violent impact of cutting material, prevent damage hole and ensure the safety of operating personnel.
5. because of the hole is especially sharp, when the center drill drill, not to force too much otherwise it will affect the service life of the hole.

1594791906954958.jpg


© Copyright: 2020 Yueqing Baiying Hardware Tools Co.,Ltd. All Rights Reserved.

IPv6 network supported

IPv6 network supported

Friendly Links :

www.dyyseo.com
top

Leave a Message

Leave a Message

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!